Designer Stamp Ink
- Remove old ink pad.
Press the 2 buttons on the side of the stamp and lightly press down on the top of the stamp body until it clicks and locks into place. Gently push the back of the ink cartridge until it slides out of the stamp body.
- Insert new ink pad.
Insert the ink cartridge (ink side down) into the slot until it clicks into place.
- Clean the silicone stamp.
Press the buttons on the side of the stamp and press down on the top of the stamp body until it clicks and locks into place. Using a damp cloth, gently wipe the ink off the silicone part of the stamp until clean.
Now, you are ready to stamp!
- Push down to lock line and slide into position.
- Pull out ink well.
- Stop when you hear a click.
- Fill each well with 15 drops of ink, then close and wait 15 minutes.